When using a fully automatic folder-gluing machine, the belt is an indispensable accessory. Belt slippage during the folder-gluing process is also common. Many novices may not know how to deal with it. So how to solve the problem of belt slippage? What's the problem? Let's take a look.
Common causes and solutions for belt slippage in fully automatic folder-gluing machines are:
1. Starting too fast can also cause slipping. At this time, it can be started slowly. If you use a squirrel cage motor, you can jog it twice and then start again, which can also effectively overcome the slipping phenomenon.
2. The initial tension is too small. Insufficient tension leaving the drum causes slipping. This situation usually occurs at startup. The solution is to adjust the tensioning device and increase the initial tension.
3. If the load is too large and exceeds the motor's capacity, it will slip. The advantage of slipping at this time is that it protects the motor. Otherwise, the motor will be burned out over time. But for operation it is a slipping accident.
4. Insufficient friction between the transmission roller and the belt causes slipping. The most common reason for this is that there is water in the bag or the environment is humid. The solution is to add some rosin powder to the drum. But be careful not to add it by hand, but use blowing equipment to avoid accidents.
5. The tail roller bearing is damaged and does not rotate, or the upper and lower roller bearings are damaged and do not rotate too much. The cause of the damage was that the tail of the aircraft floated too much and the damaged or inflexible parts were not repaired and replaced in time, which increased the resistance and caused slippage.
Now when you encounter belt slippage in a fully automatic folder-gluing machine, you can take the right medicine.